NorEast Fishing Forum banner
1 - 9 of 9 Posts

· Registered
Joined
·
582 Posts
Discussion Starter · #1 ·
Simple question just yesterday the starboard tilt was acting up intermittenly it would respond up/down and then nothing. Port enginre perfect with tilt up/down.

Today seemed to have lost all response on the starboard tilt. Looking at the OMC manual cannot figure out whether a fuse controls it or a seperate relay switch any ideas, just started yesterday out of the blue, regards Gary from the Sinestra.
 

· Registered
Joined
·
264 Posts
Gary, Similar situation in another omc outboard. Check the connections that go to the tilt from the controlbox. Those plastic clips that join the tiltcable to the cable in the box. Take them apart, clean them up and spray the cr#* out of them. See if that works.
Shag
 

· Registered
Joined
·
3,131 Posts
check the connections, hyd. fluid

First see if it works with the switch on the motor if it does then its the switch on the controls.
Then go out & buy a yamaha. But if you decide to keep it
Theres a great site that has all questions answered by certif. techs for free called Boatsetup.com
also thehulltruth.com will chime in with a bunch of outboard gearheads.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top