[pfotoole]

anyone have suggestions on how to go about making your own tail rope?

 

[Bassh0le007]

I made mine similar to this one. Use 12-15? of half inch rope with a loop spliced on both ends then crimp on a section of either rubber or nylon coated stainless cable and put a clip on the other end. Done

I like this style over straight rope because it sinks making it easier especially if you have to walk the fish through it..

Hope this helps?


This post edited by Bassh0le007 04:39 PM 05/16/2008

 

[gusto45]

that is the same as what I use for the most part. As stated above ot works good because it sinks and rope will not. One secured I swap it out for a piece of regular rope since there is less connections and can trust it more.

 

[B.Attitude]

Mine was similiar to the photo but I recommend a quality stainless swivel between the cable and rope.Sea Isle has them pre made or you can buy the components your missing.