[captainlarry84]

Fabricator

I just completed the install of a bow pulpit and windless on my 31 JC as pictured below. To finish the job I am looking for a fabricator to cut and extend the bow rail around the nose of the pulpit. Does anyone know a fabricator that will work on stainless steel to cut the old rail and weld on the rail extension? The radius bend of the nose section in 14 inches and two legs will also be needed.

 

[spygull]

Mastercraft

Try Mastercraft Elite Welding. 343 Knickerbocker Ave. Bohemia
631-589-0363.

 

[Miss Beryl Charters]

Hi Larry, I use RAM Welding quite a bit - he is around the corner
from my shop in Farmingdale. He has a mobile welder unit. Perhaps
you may want to get a # from him for the job. I have seen alot of
stainless bow rail work at his shop as well as tons of gas tank fabs.
If you do want check him out, if you stop by my shop first, I will
shoot over there with you and introduce you to Tony. Tony's # is
631 420 9594. My work # 631 420 4180.
Best,
Rick

 

[captainlarry84]

RAM

Thanks Rick, I faxed John the plans of the bowrail. They seemed easy to work with.