how warm did you get it i know the warmer you get it the faster it will set .i dont warm for the seats any more for that reason it cuts the setup time.is this the only batch you had a problem with ?if so they mite have mis labled a batch.try calling flex coat if so.
Smoking Epoxy
Just used some flex coat slow cure on a grip. Next mixed a batch for the reel seat after I rolled on some tape bushings. Same procedure each time (warmed bottles with warm tap water), same bottles of epoxy. The epoxy I mixed for the reel seat began to harden after about 7 minutes. Once it started to harden it was solid in about 2 minutes and while it was hardeneing before my eyes started to give off a white smoke. The reel seat turned as I aligned it with the spine of the rod and acted normally even when the epoxy in the cup had completely hardened. Anyone ever had this happen or know why it happened?
Thanks,
Joe
Thanks,
Joe
1 - 1 of 9 Posts
1 - 1 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
NorEast Fishing Forum
A forum community dedicated to fishers, anglers and enthusiasts in the North Eastern area. Come join the discussion about safety, gear, boats, tackle, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
