NorEast Fishing Forum banner
1 - 2 of 2 Posts

· Registered
590 Posts
Discussion Starter · #1 ·
Shakspere sent me a new tip for a 5ft ugly stik the old one had the insert fall out.I tried a lite heat with a small soldering iron but it wount budge,dont want to melt the fibre glass.The new tip looks a bit larger in diameter.Should i cut the rod??Might be better than too much heat.TIA for any help.This is a real light weight rod.

This post edited by qlty 06:05 PM 08/07/2008
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.