NorEast Fishing Forum banner
Cancel

Renzetti

1487 Views 7 Replies 6 Participants Last post by  CAPT RICHI, 
C
Should I go for a new Renzetti rod lathe???How much better is it..what advantages does this maching have over a Pac-bay or the one from Anglers Workshop???
Will Renzetti sell wholesale? I know I can get both the Pac bay & the AW lathe at wholesale prices..
I'm just fishing right now...But getting ready to move up ..
Reply
Save
Like
1 - 1 of 8 Posts
rodprof
If you build more than a dozen rods a year then I would go for the Renzetti. However, Renzetti does not sell at wholesale.

I have a Clemens lathe that's 25 years old, equivalent to the Renzetti, and it's still going strong.

Al G.
Reply
Save
Like
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
NorEast Fishing Forum
A forum community dedicated to fishers, anglers and enthusiasts in the North Eastern area. Come join the discussion about safety, gear, boats, tackle, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
The Angler's Lounge General Fishing Forum Partyboat Fishing New Member Introductions
Top