NorEast Fishing Forum banner
1 - 2 of 4 Posts

· Registered
Joined
·
84 Posts
Discussion Starter · #1 ·
I've been rebuilding a few old blanks and i have one dilema. After stripping off the guides and taking off the thread, I've been noticing that the matealic coating on the thread has been sticking to the blank. I've tried using acitone only to get frustrated. Any tips? Thanks Again

Ralph78
 

· Registered
Joined
·
84 Posts
Discussion Starter · #3 ·
Thank you

Hi Capt. Neil,
No I'm not wraping over the same area. And if I did the sand paper trick can I do it all along the blank to give it a uniform apearance? Or should I try some thing else. Thank you
 
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top