POWER WINDLASS PROBLEM

1106 Views 8 Replies 6 Participants Last post by blackfish, Jan 8, 2003

MakoMatt

Discussion Starter · Jan 8, 2003

I have a Powerwinch brand, 30' class, free fall windlass. I have been having a problem with it, quite often, the line does not grab, the metal wheel thing turns, but is not biting the line, and sometimes the line "jumps" out of the "groove" where it should be seated, even with that little spring loaded arm.

I have called Powerwinch, and they said it probably, they said 99% sure, was the line. $180 later on new line, I'm still having the same problem. I am using the recommended line, and it is the correct diameter. When it works, it works great, but when it starts acting up, it a real pain, and someone has to go up on the bow to help it along. This can be a little dangerous at times.

Anyone have any suggestions on a cure, or comments on this brand of windlass?

Thanks in advance.

MakoMatt

Save

1 - 1 of 9 Posts

616357

· #4 · Jan 8, 2003

Are the teeth of your wheel stripped or worn down?
My Simpson wheel was stripped and I had to replace the wheel. I tie off the anchor line when I am at achor to the Anchor clete and always power into the line to pull up the anchor. Depending on how old it is some internal mechanisms could be shot. I went online to the company and was given suggestions for repair.

Save

1 - 1 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month