NorEast Fishing Forum banner
1 - 2 of 2 Posts

· Registered
3,142 Posts
Discussion Starter · #1 ·
Hi Guys
I need a small 16 to 20 inch piece of rod butt ( for a repair)

One end needs to have a 20cm id to take a fuji disconnect reel seat

I have some around but nothing with a proper size ID

If anyone can find an old cut off piece from a lami 114 or other surf blank cut down to boat rod length that would be great
any material any mfg any color is ok it will all be covered. Thick wall would be best but i will take anything of proper dimmension

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.