[phenom3x16]

Hey guys, I am going fluke fishing on Wednesday and herd allot about the spro bucktail and how it works

, but i have no idea as to how it should be worked properly. All feedback will be much appreciated

BTW i will be using these two specific bucktails. Thanks guys

 

[crabman1130]

I would rig it with a teaser about 8 to 12 inches above. I just use spearing because I have too much trouble with the squid folding over and getting hooked on the Spro.
You may want to buy the Gulp chartreuse twisty tail grubs and put them on instead of the spearing.

Drop the rig to the bottom and bounce it as you drift. When you feel a hit delay on second and then set the hook.
If you are having trouble holding bottom cast up into the drift and work the jig back to the boat.

Good luck.

 

[DarthBaiter]

Cast out, hit bottom, bounce it back to boat and repeat. You can put a teaser on it, and a spearing thru the eye. On a fast drift, cast up current hit bottom bounce and bring in the slack.

 

[bigfish123]

Jig it pretty hard and fast on the bottom. I rig a 1ounce spro with a 4in gulp white mullet and a dry teaser 12 inches. Not to brag but i have outfished everyone on my boat with combo.

 

[kurt33]

it depends on how deep your fishing most of my biggest fluke have takin them dead sticked.also just fluke belly works the best and right now pink is hot in shinny and green in the peconic

 

[Gaucho]

I like to keep them at 15in apart.
Drift and bounce off the bottom every 3 seconds.

 

[Billy40]

Angle cast in the current (across) and swim it like a fly fisherman fishs a wet fly. THis allows the jig profile to be seen by the fish, swimmin gup and away from it. Persoanlly that ismy favorite technique for BTing, although it is not always possible to do due to conditions and fishing on a PB.

 

[Lindanel]

Teaser

for the teaser above the spro, what kind and size of hook should be used?

 

[Slick56]

another thread where a member asks how to catch fluke..........