NorEast Fishing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10,967 Posts
Discussion Starter · #1 ·
Hi,

Here is the formula for the cleaning solution to remove wet epoxy from the blank after installing grips and reel seats.

Mix in 1 qt. bottle
2 tablespoons Liquid Joy
4 oz. 91% Isopropyl alcohol
Add necessary water to fill bottle, shake well

After epoxying a grip or reel seat, clean area using a paper towel and alcohol several times to remove excess epoxy.

Wet paper towel with cleaning solution and scrub the area. Wipe off with new paper towel.

Reclean the area using alcohol and paper towel.

Capt Neil

Have Fun Fishing. Capt Neil
Custom Fishing Rods by Captain Neil
 
G

·
Hey Cap one addition that might help is use distilled water,should also be used in applying water slide decals will prevent the possibility of water spots on the blank some of the regular water out there can be fairly tough.
John
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top