NorEast Fishing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have a new Diawa x series 9' spin rod .I was casting a 3 oz. sinker.After each strong loaded cast I had to straighten the tip out to line up the guides.Is there anything I can do other than trying to push the tip section harder and deeper into the butt section?I don't have the capabilty to transport a 1 piece rod at this time.The tip fits inside the butt section.
 

·
Registered
Joined
·
843 Posts
if the top half turns on the two piece
turns went you cast .on the lower half
the male part. put a light coat of hard
as nails on the male part. it will make
a tighter and shouldnot turn .if it is just the tip reglue .
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top